upload
George E King Consulting Inc.
Industri: Oil & gas
Number of terms: 9502
Number of blossaries: 0
Company Profile:
George King is a technology provider in the oil and gas industry specializing in new technology and problem oil well solutions.
A casing joint with regular pattern slots of a specific phasing, width and length. Used as a simple sand control method.
Industry:Oil & gas
A casing or tubing repair technique that uses a packer at the top and bottom with a smaller diameter pipe in-between to isolate a breach in the pipe or seal off old perfs. Also used for a liner set in open hole to isolate an unstable zone or loss zone, rather than to increase the pressure containment capability of the well.
Industry:Oil & gas
A casing shoe with poor cement support.
Industry:Oil & gas
A cement job done by spotting a column of cement then lowering a liner into the cement slurry.
Industry:Oil & gas
A cement plug, set with no downhole flow conditions, which allows temporary or permanent shut-off in a well. It takes into account the densities of all fluid columns, both in the string and in the annulus.
Industry:Oil & gas
A cement repair job done by running a tube down an annulus and cementing to surface.
Industry:Oil & gas
A cement slurry, foamed with between 40 and 60% nitrogen gas. Has a slurry density of about 7.5 to 10 lb/gal (0.9 to 1.2 g/cc).
Industry:Oil & gas
A cement squeeze into a area of perforations. Often done initially over the frac pressure.
Industry:Oil & gas
A cement squeeze involving injecting into a lower perforation, separated by a packer from an upper perforation while trying to fill a channel.
Industry:Oil & gas
A cement squeeze technique where the cement is squeezed into a channel or leak at a low rate, then allowed to sit and dehydrate by leakoff, before again raising the pressure. The action gradually builds a dehydrated cement node that blocks the channel.
Industry:Oil & gas